When you work at height, “load” can mean two very different things. It might be the weight you’re lifting into position (plant, steelwork, truss, pallets). Or it might be the forces your safety system must withstand if something goes wrong. Either way, the terminology on tags, certificates and product pages matters—because choosing the wrong rating can put people and equipment at risk.
If you’ve already read our guide to the difference between WLL and SWL, this post goes one step wider. (If you haven’t, start here: What’s the Difference Between WLL and SWL?.) Below is a practical load-terminology cheat sheet, plus examples of which jobs each rating is most relevant for.
Working Load Limit (WLL) and Safe Working Load (SWL) are the ratings you’ll most often see on lifting and rigging hardware. In plain language, they point to the maximum load the product is intended to handle in service. That’s why searches like “wll meaning”, “swl meaning”, and “safe working load” come up when someone is checking whether equipment is suitable for a lift.
Use WLL/SWL when you’re selecting:
Minimum Breaking Load (MBL) or Minimum Breaking Strength (MBS) is the load where the product is expected to fail in a test. It is not the number you plan your lift around. Manufacturers apply a safety factor (also called a design factor) to turn that breaking figure into a working rating.
You’ll often see MBS language on load restraint products like heavy duty ratchet straps, where standards may show both an in-service capacity (LC) and a breaking figure.
Some lifting gear is proof tested above its working rating to confirm integrity. Proof load is not permission to lift more—it’s simply evidence the product can withstand a higher test load without permanent deformation. It’s most relevant for inspection regimes and documentation.
Construction & MEP installs: If you’re lifting plant to a roof or positioning steelwork, start with WLL/SWL on the lifting path—hoist, slings, shackles, and connectors.
Entertainment & events: Chain blocks are common for truss and staging. Match the WLL to the total suspended load, including rigging hardware.
Transport & haulage: For tie-downs, check both the LC and the MBS so you’re not overestimating strap performance.
Fall arrest equipment isn’t selected by “WLL vs SWL”. It’s certified to different standards and designed to absorb energy during a fall, not lift materials. If your job mixes lifting and working at height, keep systems distinct: use certified lifting gear for loads, and purpose-built fall protection equipment for people.
Need help picking the right kit for the job? Tell us what you’re lifting (or securing), where you’re working, and how it’s being used—then we’ll help you match the right terminology and the right equipment to your site conditions.
Locations: Bristol & West Drayton Contract: Full-Time, Permanent
SafetyLiftinGear is growing, and we’re looking for skilled, motivated Lifting Equipment Engineers to join our teams in Bristol & West Drayton.
More...
While load restraint may seem simple enough – after all, all you need to do is keep your loads secure while transporting them from A to B - we still see far too many instances of half-hearted load restraint, which all too often results in a scene like this:
Hard hats, also known as safety helmets, are more than just important, they are crucial for protecting workers from severe head injuries and even death while working on site. At construction sites, head injuries can occur in a range of ways, but by wearing the right kind of safety helmet, workers can prevent or reduce the severity of these injuries. Keep reading this blog for more reasons why hard hats are important.
A hydraulic jack is a mechanical device that lifts heavy loads by using a small force applied to hydraulic fluid to generate a much larger lifting force. They work by pumping fluid from a reservoir into a cylinder, this builds pressure that pushes the piston up, in turn raising the heavy object.
According to the Work at Height Regulations 2005, all work at height activities should be properly planned, appropriately supervised and carried out safely to avoid accidents and injuries.
EN 795 anchor points are secure attachment points that conform to the British standard EN 795 for personal fall protection equipment.
0117 9381 600
